To view the entire report
published by the Access Board, go to http://www.access-board.gov/rowdraft.htm
Accessible Public Rights-Of-Way (11/23/05)
R304 Detectable Warning Surfaces
- R304.1 General. Detectable warnings shall
consist of a surface of truncated domes aligned in a square
or radial grid pattern and shall comply with R304.
- R304.1.1 Dome Size. Truncated domes in a
detectable warning surface shall have a base diameter of 23
mm (0.9 in) minimum to 36 mm (1.4 in) maximum, a top diameter
of 50 percent of the base diameter minimum to 65 precent of
the base diameter maximum, and a height of 5 mm (0.2 in).
- R304.1.2 Dome Spacing. Truncated domes in
a detectable warning surface shall have a center-to-center spacing
of 41 mm (1.6 in) minimum and 61 mm (2.4 in) maximum, and
a base-to-base spacing of 17 mm (.65 in) minimum, measured between
the most adjacent domes.
- R304.1.3 Contrast. Detectable warning surfaces
shall contrast visually with adjacent gutter, street or highway,
or walkway surface, either light-on-dark, or dark-on-light.
- R304.1.4 Size. Detectable warning surfaces
shall extend 610 mm (24 in) minimum in the direction of travel
and the full width of the curb ramp (exclusive of flares), the
landing, or the blended transition.
R304.2 Location and Alignment
- R304.2.1 Perpendicular Curb Ramps. Where
both ends of the bottom grade break complying with R303.3.4
are 1.5 m (5.0 ft) or less from the back of the curb, the detectable
warning shall be located on the ramp surface at the bottom grade
break. Where either end of the bottom grade break is more than
1.5 m (5.0 ft) from the back of the curb, the detectable warning
shall be located on the lower landing.
- R304.2.2 Landings and Blended Transitions.
The detectable warning shall be located on the landing or blended
transition at the back of the curb.
- R304.2.3 Alignment. The rows of truncated
domes in a detectable warning surface shall be aligned to be
perpendicular or radial to the grade break between the ramp,
landing, or blended transition and the street.
|